how to drill out a lock

Most locks that can be drilled out will need to follow these steps only. 3 Drill An Empty Lock.

2 Ways To Drill Door Cylinder Lock Youtube

Make sure to put on your safety goggles before you start drilling.

. You can follow the same procedure as above. Just some eye protection a drill and a 38-inch metal drill bit. You will want to use high-speed steel HSS drill bit. Step 5 Use a 19mm Drill Bit to Completely Destroy the Lock Mechanism.

Remove the lock from the. Start Drilling through Lock Cylinder. Start with a tiny drill bit ⅛-inch bit and. Application of external force using tools like hammer pliers and other heavy.

Make Sure Drilling the Lock is Your Only Option. Using a ⅛-inch or smaller bit drill into the. Apply pressure to the drill bit and drill into the center of the ignition lock cylinder. Starting at low speed create a starter groove in the ignition lock cylinder.

How to drill Out a Lock. Drilling a lock does not necessitate the use of precision instruments but it does necessitate a well-maintained drill and a variety of drill bit. Use a smaller drill bit to bore a hole on the center of the lock. Make a Hole in the Locks Center Using a Smaller Drill Bit.

Insert a flat knife-like metal in the lock and rotate it to unlock the door. Once done use a larger drill to bore a second hole to the first one that. 1 Drilling Out A Faulty Ignition Key Lock With Drill Bit. Steps To Drill Out The Door Lock.

However the drilling angle is above the keyhole to knock out the locking mechanism. If you dont happen to have a drill bit. The groove you make is a small but not a. Right above the keyhole.

Once you have created the groove. Most traditional locks have screws or pins inside the system. Make A Guide Hole. Assemble your tools You dont need much to drill out your RV door lock.

You must position your drill precisely where the pins and springs are located and using varying size drill bits carve out a hole big. It is important to find the screws or pins to successfully remove and damage them. Want to learn how to drill out a tubular lock. Continue drilling until the drill bit breaks through the other side of the ignition lock cylinder.

It would be best to have a tiny drill bit to do it here. After unlocking the door open it and find the screw that holds the lock cylinder in the door. First make a small starter hole or groove in the lock cylinder with a hammer and center punch. Now it is time to start drilling through the cylinder.

Most locks will open up after you. 4 Drill A Lock With. Get your Gear Together. There is a method as explained in the video.

Using the drill bit method to drill out an ignition lock cylinder should be done with complete consciousness and attention. As a result of the cylinder being coupled into the handle it makes it very easy for this type of lock to be destroyed. Use ⅛ inch drill bits and start drilling the lock. Dont drill a deep hole since it can encourage the drill bit to slip.